Use SelectEnd to end select (or deselect) mode. (See Selection.)
Note that SelectEnd does not inactivate the selection but merely ends select or (deselect) mode so that the cursor can be moved to another location to begin select (or deselect) mode again. To inactivate the selection, use either the SelectOff or SelectReset command.
SelectEnd may also be entered as SelEnd.
SelectEnd has no operands.
SelectEnd is typically invoked by the Select command rather than directly. The Select command begins OR ends select (or deselect) mode based upon whether select (or deselect) mode is currently active. Where SelectEnd is invoked directly, it is typically from a procedure.
Return Codes
OK Successful.
Examples
End select (or deselect) mode:
=> selend