Use ZoneIgnore to set or reset the ZoneIgnore mode. In ZoneIgnore mode, the currently defined zones are ignored. Rather, BIM-EDIT/XP functions as if only one zone encompassing columns 1 through MaxCol were defined. (See Zones.)
ZoneIgnore may also be entered as ZoneIgn[ore].
Optional Operands
REQ Specify 'S' to set ZoneIgnore mode, 'R' to reset ZoneIgnore mode, or 'T' to toggle ZoneIgnore mode.
Default: T.
ZoneIgnore may be invoked without operands by pressing Ctrl-Z.
Return Codes
OK Successful.
Examples
Toggle ZoneIgnore mode:
=> zoneign